8720017062809

Brand: Allteq Product: Installation: built-in Connection: 3-wire (phase, neutral, switched wire) Protection: IP20 Connection type: screw terminal Detection range: up to 9 meters Detection angle: 160° Light sensitivity: 3 - 2000 lux Max. detection range: 9 meters Minimum load: 5W (LED) / 1W (standard lighting) Mounting height: 1 - 1.8 meters Type: PIR sensor - Infrared Delay time: 10 - 420 sec Power: max. 100W (LED) / 500W (standard lighting) Power supply: 230 V Dimensions: 79 x 79 x 25 mm Warranty: 5 years Allteq The Allteq PIR is a built-in detector. It can be mounted anywhere desired, as long as it can be connected to a security system. They are activated when the alarm system to which the detector is connected is armed. As soon as motion is detected, a signal is sent to the alarm system, causing it to activate. The Allteq PIR is a reliable and affordable model that can be built into any desired location. This uses PIR. PIR stands for Passive Infrared and means that the device does not consume or generate energy but only reacts to motion detected by the sensor. Use This product can be connected to an alarm system that is compatible with them. For power, the device must be connected to the mains and uses 230 volts. There is a switch on the device with which the detector can be switched on, off, or set to use PIR only. It is recommended to place a motion sensor in every room. Please note: with a low load, the LED lights may flicker after the has been switched off. Features Mounting: built-in Protection: IP20 Connection type: screw terminal Other information The maximum detection range of this detector is 9 meters with a detection angle of 160 degrees. For power, it uses mains electricity with 230 volts. The dimensions of this product are 79 millimeters long by 79 millimeters wide. The built-in depth of the device is 25 millimeters. To fully utilize the quality of this product, the device must be mounted at a height of at least 1 meter and no higher than 1.8 meters above the ground. The light sensitivity of the sensor is 3 – 2000 lux. The delay time is 10-420 seconds. This infrared has IP20 protection. The detector is suitable for LED lighting from a power of 5 W and standard lighting from 1 W. The switching capacity is a maximum of 100 W for LED lighting and a maximum of 500 W for standard lighting. Warranty is 5 years. Ask a product question